※こちらの商品は未開封の状態で入荷しましたが 当方にて確認のため開封後コンソールでログ出力の確認まで行いました。
Total memory size = 512 MB C841M-4X-JSEC/K9 platform with 524288 Kbytes of main memory Main memory is configured to 32 bit mode Readonly ROMMON initialized IOS Image Load Test ___________________ Digitally Signed Production Software Self decompressing the image : ###################################################################################### ###################################################################################### ###################################################################################### ###################################################################################### ###################################################################################### #################################################################################### [OK] *** No sreloc section Smart Init is enabled smart init is sizing iomem TYPE MEMORY_REQ Onboard devices & buffer pools 0x01AECEC0 ----------------------------------------------- TOTAL: 0x01AECEC0 Rounded IOMEM up to: 26Mb. Using 5 percent iomem. [26Mb/512Mb] Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706
Cisco IOS Software, C800M Software (C800M-UNIVERSALK9-M), Version 15.5(3)M, RELEASE This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately. If you require further assistance please contact us by sending email to export@cisco.com. Installed image archive Cisco C841M-4X-JSEC/K9 (revision 1.0) with 496716K/27571K bytes of memory. Processor board ID FGL202621KJ 6 Gigabit Ethernet interfaces 1 Virtual Private Network (VPN) Module DRAM configuration is 32 bits wide 255K bytes of non-volatile configuration memory. 1916928K bytes of SD Flash sdflash (Read/Write)
Press RETURN to get started! *Jan 2 00:00:00.663: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name = c800m Next reboot level = advsecurity and License = advsecurity *Nov 10 09:16:53.343: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State changed to: Initialized *Nov 10 09:16:53.347: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State changed to: Enabled *Nov 10 09:17:03.251: %LINK-3-UPDOWN: Interface GigabitEthernet0/4, changed state to down *Nov 10 09:17:03.251: %LINK-3-UPDOWN: Interface GigabitEthernet0/5, changed state to down *Nov 10 09:17:04.123: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down *Nov 10 09:17:04.251: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/4, changed state to down *Nov 10 09:17:04.251: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/5, changed state to down *Nov 10 09:17:13.079: %SYS-5-LOG_CONFIG_CHANGE: Buffer logging: level warnings, xml disabled, filtering disabled, size (51200) *Nov 10 09:17:13.483: %SYS-5-CONFIG_I: Configured from memory by console *Nov 10 09:17:15.535: %LINK-5-CHANGED: Interface GigabitEthernet0/4, changed state to administratively down *Nov 10 09:17:15.535: %LINK-5-CHANGED: Interface GigabitEthernet0/5, changed state to administratively down *Nov 10 09:17:16.819: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to down *Nov 10 09:17:16.819: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to down *Nov 10 09:17:16.819: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to down *Nov 10 09:17:16.819: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/3, changed state to down *Nov 10 09:17:22.111: %SYS-5-RESTART: System restarted -- Cisco IOS Software, C800M Software (C800M-UNIVERSALK9-M), Version 15.5(3)M, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2015 by Cisco Systems, Inc. Compiled Thu 23-Jul-15 03:45 by prod_rel_team *Nov 10 09:17:22.403: %SSH-5-ENABLED: SSH 1.99 has been enabled ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device. This feature requires the one-time use of the username "cisco" with the password "cisco". These default credentials have a privilege level of 15. YOU MUST USE CISCO CP or the CISCO IOS CLI TO CHANGE THESE PUBLICLY-KNOWN CREDENTIALS Here are the Cisco IOS commands. username <myuser> privilege 15 secret 0 <mypassword> no username cisco Replace <myuser> and <mypassword> with the username and password you want to use. IF YOU DO NOT CHANGE THE PUBLICLY-KNOWN CREDENTIALS, YOU WILL NOT BE ABLE TO LOG INTO THE DEVICE AGAIN AFTER YOU HAVE LOGGED OFF. For more information about Cisco CP please follow the instructions in the QUICK START GUIDE for your router or go to http://www.cisco.com/go/ciscocp----------------------------------------------------------------------- User Access Verification Username: cisco Password: % Password expiration warning. ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device and it provides the default username "cisco" for one-time use. If you have already used the username "cisco" to login to the router and your IOS image supports the "one-time" user option, then this username has already expired. You will not be able to login to the router with this username after you exit this session. It is strongly suggested that you create a new username with a privilege level of 15 using the following command. username <myuser> privilege 15 secret 0 <mypassword> Replace <myuser> and <mypassword> with the username and password you want to use. ----------------------------------------------------------------------- yourname#show version Cisco IOS Software, C800M Software (C800M-UNIVERSALK9-M), Version 15.5(3)M, RELEASE ROM: System Bootstrap, Version 15.5(1r)T1, RELEASE SOFTWARE (fc1) yourname uptime is 4 minutes System returned to ROM by power-on System image file is "flash:c800m-universalk9-mz.SPA.155-3.M.bin" Last reload type: Normal Reload Last reload reason: power-on
This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately. If you require further assistance please contact us by sending email to export@cisco.com. Cisco C841M-4X-JSEC/K9 (revision 1.0) with 496716K/27571K bytes of memory. Processor board ID *********** 6 Gigabit Ethernet interfaces 1 Virtual Private Network (VPN) Module DRAM configuration is 32 bits wide 255K bytes of non-volatile configuration memory. 1916928K bytes of SD Flash sdflash (Read/Write) License Info: License UDI: ------------------------------------------------- Device# PID SN ------------------------------------------------- *1 C841M-4X-JSEC/K9 ***********
License Information for 'c800m' License Level: advsecurity Type: Permanent Next reboot license Level: advsecurity Configuration register is 0x2102 yourname#
外観の状態に関しましては傷一つなく極上美品です。 ネットワークを介しての確認は、行っておりません。 商品説明欄と異なる状態であった場合のクレームをお受けする期日は、 商品のお届け後、1週間以内とさせていただきます。 それ以降は一切お受けしませんので、速やかなチェックをお願いいたします。
入札前の下見は歓迎いたしますので、ストア情報にある電話番号にてお問い合わせください。 |